Network Repair · April 18, 2026 · Network Engineer

WiFi Keeps Dropping? Router Placement + Settings Complete Guide

Paying for 1000M broadband but WiFi gives you only tens of Mbps? The problem is usually not slow broadband but WiFi settings and placement.

WiFi Keeps Dropping? Router Placement + Settings Complete Guide

Paying for 1000M Broadband but Getting Tens of Mbps on WiFi? You're Not Alone

According to OFCA's 2025 report, Hong Kong residential broadband averages 280Mbps, with over 65% of households using 1000M or faster fiber broadband. But ironically — the same OFCA report shows actual WiFi speed tests in HK homes average just 85Mbps. In other words, most Hong Kongers are only using about one-tenth of what they're paying for. The problem isn't your broadband provider — it's your WiFi router placement, settings, and hardware limitations. Let's optimize your WiFi, step by step from simplest to most advanced.

Step 1: Router Placement — The Most Common Mistake

WiFi signals are fundamentally radio waves, and they get absorbed or reflected by walls, metal, water (including people and fish tanks). Here are the golden rules for router placement:

Where to place it:

  • Central location in the home, elevated 1-1.5m high (roughly on a cabinet or shelf)
  • Open area with no large metal objects nearby
  • Away from corners, away from windows (signal goes straight out)

Never place it:

  • Inside a TV cabinet (metal frame + TV itself = signal prison)
  • In the kitchen (microwave operation severely disrupts 2.4GHz WiFi)
  • Near a fish tank (water is WiFi's enemy)
  • On the floor (furniture and flooring absorb the signal)

Hong Kong apartments are typically long and narrow (living room at one end, bedrooms at the other). If your router is in the living room, the far bedroom is usually a "WiFi dead zone." If this describes your situation, you need to consider a Mesh WiFi system (detailed below).

Step 2: Choose the Right Band — Why Your Neighbors Affect You

WiFi has two main frequency bands — 2.4GHz and 5GHz. Each has pros and cons:

Band2.4GHz5GHz
Wall penetrationStrong (can penetrate 1-2 concrete walls)Weak (significant degradation through one wall)
Max speed~100Mbps (real-world)~500-800Mbps (real-world, WiFi 6)
InterferenceHeavy (neighbors, Bluetooth, microwaves)Less
Non-overlapping channelsOnly 3 (1, 6, 11)Many non-overlapping channels
Best forLong range, smart home devicesHigh-speed downloads, gaming, 4K streaming

Pro tip: Modern WiFi 6/6E routers support "Band Steering," automatically assigning devices to the best band. If you're still on WiFi 5 or older, manually configure — devices near the router on 5GHz, distant devices on 2.4GHz.

Step 3: Change the Channel — Check for "Traffic Jams"

If you live in a large housing estate (e.g., Mei Foo Sun Chuen, City One Shatin, Whampoa Garden), there may be dozens or even hundreds of WiFi networks on your floor competing for channels. All routers default to channels 1, 6, or 11, creating congestion.

Solution:

1. Download WiFi Analyzer app (Android) or use Airport Utility (iOS) to scan nearby WiFi

2. See which channel is least crowded

3. Go to your router's admin page and manually set a less-crowded channel

4. The 5GHz band, having many more channels, is typically less congested than 2.4GHz

If you're using a WiFi 6E router (supporting the 6GHz band), interference is essentially a non-issue — 6GHz is still a "private road."

Is Mesh WiFi Worth the Investment? Let's Do the Math

ComparisonTraditional Router (Single Unit)Mesh WiFi System (2-3 Nodes)
Coverage400-600 sq ft (through one wall)1,500-3,000 sq ft (depending on nodes)
Price (Entry)$300-$800$600-$1,500 (2-pack)
Price (High-End)$1,500-$3,000$2,000-$5,000
SSID ManagementSingle SSIDOne unified SSID, seamless switching
Dead Zone HandlingNeed extender (but speed halves)Seamless handoff between nodes, no speed loss
Best ForUnder 400 sq ft, open-plan/1-bedroom700+ sq ft, duplex, 3+ bedrooms
Setup Difficulty★☆☆★★☆ (most have app guidance)

If your home exceeds 700 sq ft or has 3+ bedrooms (especially long layouts with corridors), Mesh is essential. Recommended models:

  • Budget Pick: TP-Link Deco X50 (AX3000, 2-pack ~$700)
  • Value Pick: TP-Link Deco XE75 (AXE5400, tri-band WiFi 6E, 2-pack ~$1,500)
  • Premium Pick: ASUS ZenWiFi XT9 (AX7800, 2-pack ~$3,000)

Step 4: WiFi Security — Don't Let Freeloaders Slow You Down

Someone stealing your WiFi isn't just a security issue — it directly slows your network. Basic WiFi security settings:

  • Encryption: Must use WPA2-AES or WPA3. If you see WPA/WPA2-TKIP, change it — TKIP has been cracked.
  • Password strength: Minimum 12 characters with uppercase, lowercase, numbers, and symbols. Avoid phone numbers, birthdays, or "password123" type passwords.
  • Disable WPS: WiFi Protected Setup is convenient (push a button to connect) but is a known security vulnerability. Turn it off.
  • Disable WAN management: Don't allow external internet access to your router's admin page.
  • Regular firmware updates: Routers also need security patches. Check the management page for new firmware.

Pro Tip: Free 3-Step WiFi Optimization

ComputerKing Network Engineer's Advice: If your WiFi is slow but you don't want to spend money on new equipment, try these three free steps: ①Reposition — moving the router to a more central, higher position can immediately improve speed by 20-40%; ②Change channel — switching from a congested channel to a less crowded one can sometimes double speed instantly; ③Upgrade the LAN cable connecting your modem and router (use Cat6 or above) — sometimes the problem is just an old cable that can't handle gigabit speeds. These three zero-cost steps often solve the majority of problems.

FAQ

Q: What's the difference between a WiFi Extender (Repeater) and Mesh? Which is better?

A: An extender receives the router's signal and "re-broadcasts" it, but speed is halved (half the bandwidth is used to communicate with the router). Mesh systems have a dedicated backhaul channel between nodes (especially tri-band Mesh), so speed doesn't get halved. For larger homes, Mesh is the better investment. Extenders work for small apartments where only one or two spots have poor reception.

Q: Why does my router claim 3000Mbps but I only get 200Mbps?

A: The "AX3000" number on the box is theoretical maximum speed, adding together the maximum speeds of both 2.4GHz and 5GHz bands. Real-world conditions include walls, distance, interference, and device limitations (your phone might only support 2×2 MIMO), so actual speed is typically 20-40% of the theoretical value. This is normal.

Q: Do I need WiFi 7?

A: Not in 2026. WiFi 7 routers start at $3,000+, and very few devices (phones, notebooks) support WiFi 7 yet. Unless you're an extreme gamer or doing heavy NAS data transfers, WiFi 6 or 6E is more than sufficient.

Q: How much does an on-site WiFi inspection cost?

A: ComputerKing's on-site WiFi inspection service starts at $300 (includes signal testing, interference analysis, and placement recommendations). If you subsequently purchase Mesh installation or router upgrade services from us, the inspection fee is deductible.

Still Can't Get It Working? Let Us Help On-Site

WiFi problems sometimes genuinely require an on-site visit to diagnose — maybe your neighbor installed an industrial-grade router interfering with the entire floor, maybe your apartment's structural walls have steel reinforcement blocking the signal, maybe there's an issue with your fiber line itself. We can visit your home to test signal strength, reposition and configure equipment, or help you select and install the most suitable Mesh system for your home.

📞 Want fast, stable WiFi? WhatsApp 2115 9219 to book an on-site inspection. Want to buy a router yourself first? Check out our 2026 Router Buying Guide.

*Last updated: July 25, 2026. Written by the ComputerKing Network Engineer Team, which has helped over 500 households optimize their WiFi networks.*

Frequently Asked Questions

WiFi keeps dropping?

Try 5GHz, elevate the router centrally, avoid microwaves. May need a newer router.

No WiFi in the bedroom?

HK's thick walls block signals. 2.4GHz penetrates better than 5GHz. Add Mesh or cable.

Slow speed — router's fault?

Not necessarily. Test wired first — if wired is slow, it's the ISP. If only WiFi is slow, it's the router.

Is Mesh WiFi worth it?

Worth it for large flats. Small flats are fine with one good router.

WhatsApp 2115 9219